LEFT INNER TIE ROD SEE FULL PAGE FOR FIT

. Makes changing faulty inner tie rods simple and pain free.

Moog ES3488 Tie Rod End

$54.99
  • Review
  • TAG : 1963 VW KHARMAN GHIA INNER TIE ROD LEFT
ADD TO CART
  • I had a bent front inner tie rod, and this thing was super easy to install. The only thing I don't like is that there is no replacement clamp for the one time use clamp.

    2004 Yukon XL 2wd
    My original inner tie rods lasted 250,000 miles, the Moog joints wore out in 40,000 miles. Lifetime warranty is worthless when you have to spend $100 to realign your car with every joint replacement.

  • 2004 Yukon XL 2wd
    My original inner tie rods lasted 250,000 miles, the Moog joints wore out in 40,000 miles. Lifetime warranty is worthless when you have to spend $100 to realign...

    I haven't driven the car a whole lots since I replaced the inner tie rod end but the installation was easy and everything fit. The look is nice(not that you really see it but mentally you know it's there and looks good). I put average for the handling improvement becasue I didn't have bad handling before I replaced them, they were getting loose but not where I could feel it in the steering. I replaced my outer tie rod ends also with the product from AM and that went well as well and did both at the same time. Excellent rating well earned by AM. Keep it up!

    plano-doug 04-25-2015 05:40 AM

    Quote:

    Originally Posted by SSKid (Post 2069610)
    Hi, I am a new Impala owner and mine needs work. One of the task is a inner tie rod. When taking the boot off I noticed there is a yellow plastic cover where I would normally put the inner tie rod tool (looks like a mag light). Am I supposed to break this cover off to remove the tie rod?

    It should slide off. Keep in mind, the manuals recommend removing the rack before torquing on the inner tie rods. I think the fear is that it can damage the seals in the rack.

    Doug

    .

  • SSKid 04-24-2015 04:17 PM

    Inner Tie Rod Plastic Cover
     
    Hi, I am a new Impala owner and mine needs work. One of the task is a inner tie rod. When taking the boot off I noticed there is a yellow plastic cover where I would normally put the inner tie rod tool (looks like a mag light). Am I supposed to break this cover off to remove the tie rod?


    Thanks,

    Front inner tie rod the Nissan Skyline BNR32. These tie rods often need to replaced after years of hard use. We sell these Genuine Nissan front inner tie rods as they are the best quality, and perfect fitment.

1963 VW BEETLE INNER TIE ROD LEFT

I guess, I will have to wait until I get all of the parts needed to start the replacement project of the tie rods. I will have a better idea once I open the inner tie rod boot.